roksan SARA Tonearm Guía Y Manual Del Producto página 3

T O F I T T H E S A R A T O T H E T U R N T A B L E :
1. Remove the arm collar and arm collar fixing nut from the box
2. Gently drop the arm collar through the mounting hole from above
3. Whilst holding the collar in place, fit the arm collar nut from beneath so that the
ridge on the nut fits against the arm board and gently tightening until finger tight.
It is recommended that the two grub screw holes on the side are at roughly 11 and
2 O'clock position when looking from the front of the turntable.
4. Gently drop the arm carrier in to the hole in the arm collar from above
5. Lift it up leaving about 5 or 6mm gap between it and the collar. Align the assembly
so that it points towards the front of the turntable with the arm-lift lever on the right.
Using the 3mm allen key provided tighten the grub screws on the side of the arm
collar.
2 roksan.com
6. Ensure the arm retaining clip is open.
7. Remove the arm tube (wand) from the box. With one hand, gently grip the arm
tube and support the 5-pin plug for safety.
8. Whilst holding the flying lead and
5-pin connector clear, carefully
position the recess on the
underside of the arm carrier over
and on to the bearing seat
ensuring it self locates. Do not
allow it to 'drop'.
9. Swing the arm tube into the rest
and lock in place by closing the
arm clip.
10. Ease the 5-pin plug in to the
socket being careful not to
misalign the pins. The cable
should be arranged in an arc.
11. Remove the counterweight from the box and slide
over the counter weight peg at the rear of the arm
12. Slide fully forward and nip the grub screw up using
the 2.5mm allen key
Sara 3