roksan SARA Tonearm Guía Y Manual Del Producto página 6

24. Recheck the alignment at point 'C'. Get as close to the ideal at both points by
repeating step 22 at both points. Once achieved, tighten the cartridge bolts up
25. Repeat steps 8 to 11 as the tacking weight (down-force) will need readjustment
26. Put the mat and the record back on the platter and remove the anti-skate weight
from the box
27. Fit the anti-skate weight's loop (at the end of the thread) over the upper small
horizontal bar (anti-skate peg) on the side of the arm carrier. Push the loop along to
the inner most groove. Drape the thread over the anti-skate hanger in front of the
anti-skate peg so that weight hangs freely and rises as the arm travels towards the
centre of a record
28. To check the azimuth of the arm, gently lower the arm and cartridge on to the
record about 1 or 2 cm's from the beginning without switching the turntable on
29. Looking from the front down the length of arm see if the head shell is parallel left to
right with the record surface
30. If adjustment is required, remove the Azimuth weight from the box and its bag.
Return the arm to its rest and close the arm retaining clip. If no adjustment is
needed continue to step 34
8 roksan.com
31. Fit the Azimuth weight to the lower of the two horizontal bars on the left of the arm
carrier and push fully inboard.
32. Adjust the azimuth of the arm by sliding the weight along the bar accordingly.
Recheck by moving the arm back on to the record to see if it is now parallel. Repeat
this until the head shell is parallel with the record.
33. When the head shell is parallel left to right, return the arm to its rest, close the clip
and tighten the azimuth weight's grub screw up
34. If you wish to recheck arm height, cartridge alignment, azimuth and cartridge
tracking weight (down-force), please do
35. Plug the RCA plugs of the HDC lead in to the inputs of your phono stage or phono
input on your amplifier
36. Put on a record, turn on the turntable and enjoy the music
Sara 9