<For beginners/those with
sensitive skin>
• We also recommend to use the
SOFT mode rotation. (
Using the gentle cap for legs/arms
that comes with the skin guard is
recommended for people using the
epilator for the first time or for
those with sensitive skin.
The gentle cap for legs/arms has a
skin protector for gentler epilation,
to remove hair by holding the skin
down to reduce pain.
<Tips for best epilation results>
• Massaging with a body puff may
help to prevent ingrown hairs.
• Reddening might appear after
use. A cool towel will help if you
feel pain or there is a rash.
• If your skin gets dry after epilation,
we recommend applying a moisture
lotion two days after epilation.
• Make sure skin is clean before
and after use.
<Best hair length for epilation>
Trim your hair before epilating for
the first time or if you have not
epilated for a long time. Hair
removal is easier and less painful
when the hair is short.
Shaver head
WET Shaving with soap lather
makes the skin slippery for a closer
shave. For DRY shaving, step 3 is
unnecessary. Before DRY shaving,
wipe dry any moisture or sweat from
the skin.
1
1
Attach the shaver head [F].
• Confirm the bikini comb [E] is
2
2
Check that the outer foil is not
deformed or damaged.
3
3
Wet your skin and put shower
gel on your skin.
20
EL9A-7A v7.indb 20
Page 18)
detached.
• Do not use a shower gel with a
scrub or with granular salt. Also
do not use shaving cream, skin
cream or skin lotion.
Doing so may clog the blade
and cause a malfunction.
4
4
Select the mode by pressing
the power switch [Kr].
• Press gently so that the whole
blade is in close contact with the
skin and the surface of the blade
does not move up and down.
Foot care head
ES-EL9A
• The foot care head cannot be used
in a bath or shower.
• Before use, be sure to fully charge
the appliance.
• We recommend using the product
within 30 minutes after bathing or
showering. With the feet clean,
wipe off any water on the skin.
• Each use should be approximately
10 minutes (5 minutes on each
foot, 10 minutes total for both feet).
1
1
Attach the foot care head [H].
• Push down firmly until you hear
a "click".
2
2
Select the mode by pressing the
power switch [Kr].
• POWER mode is
recommended for rotation
speed. (
Page 18)
3
3
Bring the foot care head into
contact with the skin, and
begin filing.
The basics of foot care
Use the product only for filing
calluses and hardened skin on the
feet. (Fig. 15)
2018/12/14 下午8:49