Replacing The Outer Foil And The Inner Blade - Panasonic ES-EL9A Instrucciones De Operación

• Take care not to damage the skin
protector, the frame, the caps for
legs/arms and for underarms/
bikini‑line during cleaning.
Dry cleaning [ABCDEF]
Epilation head/Shaver head
1. Lift the caps and the frame
upward while holding the cap
release ribs [ABC2] or
remove the frame by pushing
the frame release button [F0].
(Fig. 19)
2. Clean the caps [ABC], the
epilation head [D] and the
shaver head [F] with the
cleaning brush [M]. (Fig. 20)
Wet cleaning
[ABCDEFHIJ]
Epilation head/Shaver head
(Fig. 21)
1. Wet the discs and blades, and
then apply liquid hand soap.
2. Turn the switch on and then
foam is created.
3. Wash the head with water to
wash out hair.
• Do not use hot water.
• If soap is not completely washed
away, then a white deposit can
accumulate and prevent the
discs and the blades from
moving smoothly.
• Rinse the shaver head with the
frame removed.
4. Turn the switch off, wipe the
appliance with a dry cloth and
dry it well.
(Fig. 22)
1. Apply liquid hand soap to the
central part of the file.
2. Pour a small amount of water on
the file and turn the switch on.
22
EL9A-7A v7.indb 22
Foot care head
3. Rinse any debris thoroughly
with water or lukewarm water.
4. After turning the switch off,
remove the frame and rinse inside.
5. Wipe with a dry cloth and dry in
a well‑ventilated location.
Sonic scrub brush and brush head
(Fig. 23)
1. Press the power switch to turn
on the power, and thoroughly
rinse debris from the sonic
scrub brush.
2. Press the power switch to turn
off the power, remove the
brush head, and thoroughly
rinse the underside of the
brush head.
3. Wipe the appliance with a dry
cloth and dry it well.
• To protect deformation of the
brush, dry it facing upward, and
then store the brush.
Replacing the outer foil
and the inner blade
We recommend replacing the outer
foil [F5] every year and the inner
blade [F9] every two years.
Remove the outer foil of the shaver
head [F] only when replacing it.
Replacing the outer foil (Fig. 24)
1. While pushing the outer foil gently
with the fingers, use a fingernail
to release the plastic panel (b) on
the blade from the hooks (a) on
the inside of the frame.
2. The new outer foil should be
slightly bent and pushed in
until it is hooked in the frame.
2018/12/14 下午8:49