Atlas Copco G2417-S180 Manual Del Usuario página 11

G2417-S180
• Do not mix mm shanks with inch collets and vice versa
• Observe a min of 10 mm (0.4") axial grip of the shank
• When fitting mounted wheels or burrs, reduce the overhang by pushing the
shank all the way into the collet (Check also the recommendations given by
the tool manufacturer)
• Observe that increased overhang of shank reduces permissible speed
• Before starting the machine, check that the collet is properly tightened
• Test run every new mounted wheel in a safe position for 30 seconds. Be
sure to use a barrier (such as under a heavy work table) to stop any possible
broken wheel parts. Stop immediately if vibration is excessive
Legend to page 2
C Operation instructions
D Attach collet and shank
E Press safety catch forward and press trigger to start
F Air hose size: 13 mm (1/2 ")
G Maximum air pressure: 6.3 bar ( 90 psig)
EN
© Atlas Copco Industrial Technique AB - 9836 9904
Operation
11