Compressed Air Connection - Atlas Copco G2417-S180 Manual Del Usuario

G2417-S180
Installation
Installation requirements
Air quality
• For optimum performance and maximum product life we recommend the
use of compressed air with a maximum dew point of +10°C (50°F). We also
recommend to install an Atlas Copco refrigeration type air dryer.
• Use a separate air filter which removes solid particles larger than 30 mi-
crons and more than 90% of liquid water. Install the filter as close as possi-
ble to the product and prior to any other air preparation units to avoid pres-
sure drop.
Make sure that the hose and couplings are clean and free from dust before
connecting to the tool.
Both lubricated and lubrication free products will benefit from a small
quantity of oil supplied from a lubricator.
Air lubrication guide
Brand
Atlas Copco
Q8
Shell

Compressed air connection

WARNING Air under pressure can cause serious injury
Always shut off the air supply, drain hose of air pressure and disconnect
►
the tool from air supply; when not in use, before making any adjustments
to the product - for example changing accessories, or when making re-
pairs.
WARNING Whipping hoses can cause serious injury
Always make sure that there are no damaged or loose hoses or fittings.
►
WARNING Working pressure
Do not exceed the maximum working pressure.
►
For correct air pressure and hose size, see section Technical data.
Make sure that the hose and couplings are clean and free from dust before
connecting to the tool.
Installation instructions
Installation of vibrating tools
It is recommended that a minimum length of 300 mm (12") of flexible hose for
compressed air is inserted between a vibrating tool and the quick-action cou-
pling.
EN
Air lubrication
Optimizer (1 liter) 9090 0000 04
Chopin 46
Shell Air Tool Oil S2 A 320
© Atlas Copco Industrial Technique AB - 9836 9904
Installation
7