Removing Wireless Imager; Installing Wireless Lan Card - Sanyo POA-WL11 Operación Manual

2.2. Removing Wireless Imager

[CAUTION] Before removing Wireless Imager from the projector, be sure to disconnect the
projector's power plug from AC outlet. Do not remove Wireless Imager to the
projector while its power plug is connected to AC outlet. It may result in damaging
the device.
1. Press the Latch Button to the direction of the arrow (as shown in Figure 3), and gently detach
Wireless Imager from the projector.
[CAUTION] Forcibly detaching the unit off the projector may cause damages.

2.3. Installing Wireless LAN Card

[CAUTION] Before installing the wireless LAN card, be sure to disconnect the projector's power
plug from AC outlet. Do not install wireless LAN card while projector's power plug is
connected to AC outlet. It may result in damaging the device.
1. Insert the wireless LAN card into wireless LAN card Slot.
[CAUTION] Be sure to insert the wireless LAN card with the correct side facing up. Inserting the
card with wrong side will result in damaging the device.
Use only the wireless LAN card that is supplied with Wireless Imager. Wireless
Imager does not support any other wireless cards. Attempting to install unsupported
card may damage the unit.
Wireless LAN card
Figure 3
Press Latch Button to left
and pull back the unit
Figure 4
Insert with ▲ mark facing front
Make sure that the wireless LAN card is
inserted and seated firmly
— 19 —
Chapter 2. Connection