Advanced Setup - Tcp/Ip - Sanyo POA-WL11 Operación Manual

4.3.3. Advanced setup - TCP/IP

On the TCP/IP setup screen of the advanced setup, TCP/IP related items of Wireless Imager can be set.
Parameter
IP Configuration Method
IP Address
Subnet Mask
Gateway Address
A desired IP address setup method is selected from [Manual], [DHCP],
and [BOOTP].
If [DHCP] or [BOOTP] is selected, the IP address is assigned
automatically as [DHCP client] or [BOOTP client]. At this time, it is
absolutely necessary that the DHCP server/BOOTP server must be in the
environment allowing the network communication.
[NOTE] When the IP Address Configuration Method is set to DHCP or BOOTP, and you
press the test switch to display the settings while Wireless Imager is attempting to
obtain an IP address, IP Address, Subnet Mask, and Gateway Address fields will
display [-.-.-.-].
Likewise, if you attempt to display the current settings on the projector's menu
while Wireless Imager is attempting to obtain an IP address, the existing values of
IP address, Subnet Mask, and Gateway Address will be shown. Once the IP
address is obtained from DHCP server, the menu screen will display the obtained
IP address.
If Wireless Imager fails to obtain IP address from DHCP server or BOOTP server,
the existing IP address will be assigned.
Set the IP address in the environment you wish to use.
If [IP Configuration Method] is set at [DHCP] or [BOOTP], this setting is
not needed.
Set the Subnet mask in the environment you wish to use.
If [IP Configuration Method] is set at [DHCP] or [BOOTP], this setting may
become unnecessary depending on the settings of [DHCP Server] and
[BOOTP Server].
Set the gateway address in the environment you wish to use.
If [IP Configuration Method] is set at [DHCP] or [BOOTP], this setting may
become unnecessary depending on the settings of [DHCP Server] and
[BOOTP Server].
If any segment beyond the router is not used, the gateway address can be
left at "255.255.255.255".
— 35 —
Chapter 4. Setting up Wireless Imager
Description