Mode Only) - Sanyo POA-WL11 Operación Manual

Chapter 4. Setting up Wireless Imager
1. Make sure that the DIP switch on the back panel of Wireless Imager is set in the "802.11AdHoc"
mode. (DIP Switch 1 - OFF : See [1.4. Part names and functions of Wireless Imager] in Chapter 1.)
[CAUTION] Before removing Wireless Imager, be sure to disconnect the projector's power
2. Set the wireless communication conditions for the personal computer so that the communication can
be performed with the factory default settings of Wireless Imager.
Set (or change) the following three items.
[Wireless]
1) Communication mode:
2) SSID:
3) WEP ON/OFF:
[NOTE] For instructions on how to configure wireless settings for the wireless LAN card, refer to
the user's guide of the wireless LAN card.
After completing the settings, go to [4.2. Setting the IP address with WI Set].
4.1.2. Setting the personal computer (with wireless LAN card applicable to "Pseudo
AdHoc" mode only)
The personal computer needs the wireless LAN card (adaptor) that allows the wireless LAN
communication (applicable to IEEE.802.11b).
Some wireless LAN cards cannot set the communication mode to "Pseudo AdHoc". In this case, make
the preparations while referring to section [4.1.1. Setting the personal computer (with wireless LAN card
applicable only to "802.11 AdHoc" mode)].
1. Change the DIP switch on the back panel of Wireless Imager to "Pseudo AdHoc" mode (DIP Switch
1 - ON : See [1.4. Part names and functions of Wireless Imager] in Chapter 1.)
[CAUTION] Before removing Wireless Imager, be sure to disconnect the projector's power
2. Set the wireless communication conditions for the personal computer so that the communication can
be performed with the factory default settings of Wireless Imager.
Set (or change) the following three items.
[Wireless]
1) Communication mode:
2) Adhoc channel:
3) WEP ON/OFF:
[NOTE] For instructions on how to configure wireless settings for the wireless LAN card, refer to
the user's guide of the wireless LAN card.
After completing the settings, go to [4.2. Setting the IP address with WI Client].
plug from AC outlet. Do not remove Wireless Imager to the projector while its
power plug is connected to AC outlet. It may result in damaging the device.
802.11 AdHoc (Some manufacturers may use AdHoc or other words.)
WIRELESS (Uppercase)
Disable
plug from AC outlet. Do not remove Wireless Imager from the projector while its
power plug is connected to AC outlet. It may result in damaging the device.
Pseudo AdHoc (Some manufacturers may call it AdHoc or peer-to-peer)
11
Disable
— 26 —