Special Safety Directions For The Device - Deltafox DP-ERS 8010 Traducción Del Manual De Instrucciones Original

GB
Any power tool that cannot be con-
trolled with the switch is dangerous
and must be repaired.
• Disconnect the plug from the pow-
er source and/or the battery pack
from the power tool before making
any adjust -ments, changing acces-
sories, or storing power tools. Such
preventive safety measures reduce
the risk of starting the power tool ac-
cidentaIly.
• Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to oper-
ate the power tool. Power tools are
dangerous in the hands of untrained
users.
• Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
• Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less Iikely to
bind and are easier to control.
• Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions
and the work to be performed. Use
of the power tool for operations differ-
ent from those intended could result in
a hazardous situation.
• Keep handles and grip surfaces
dry, clean and free from oil and
grease. Slippery handles and grip
surfaces do not permit safe operation
and control over the power tool in un-
expected situations.
56
5) SERVICE
• Have your power tool serviced by
a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
power tool is maintained.
Special Safety Directions for
the device
1) SAFETY INSTRUCTIONS FOR
PENDULUM SABRE SAW
• Hold the electric tool by the insu-
lated gripping surfaces when per-
forming work in which the cutting
tool may come into contact with
hidden wiring. Contact with a live
wire can also cause a charge in metal
parts of the device and result in an
electric shock.
• Fasten and secure the workpiece
by means of clamps or with ano-
ther method on a stable under-
ground. If you hold the workpiece
only with your hand or against your
own body, it will stay instable and this
can lead to a loss of control.
2) SPECIAL SAFETY INSTRUCTIONS
FOR RECIPROCATING SAWS
• Hold the electric tool by the insu-
lated gripping surfaces when per-
forming work in which the cutting
tool may come into contact with
hidden wiring. Contact with a live
wire can also cause a charge in metal
parts of the device and result in an
electric shock.
• Keep hands away from the sawing
area. Do not reach underneath the