Power Control; Turning Off The Device - Sinbo SFH 3365 Manual De Instrucciones

POWER CONTROL

• Power output can be set by switching the output regulator. Convector has two power
levels: 1 and 2.

TURNING OFF THE DEVICE

• To turn the device off, put a power regulator to 0 or disconnect the power cord.
WARNING: To avoid heat loss room should be kept closed, otherwise it will not get warm.
CLEAN AND CARE
• The convector should be cleaned regularly to wipe out the dust on the surface. As this
may result the convection efficient.
• Unplug from the power supply and allow the appliance to cool down.
• Wipe out with a soft damp cloth. Do not use detergent or abrasives.
• Do not scrap the surfaces of fins with sharp hard tools, to avoid surfaces getting rusty,
because of damage of the paint coat.
STORAGE
• Switch off and unplug the appliance. Ensure the convector is completely cool.
• Complete all requirements of chapter CLEAN AND CARE.
• Reel on the power cord.
• Keep the appliance in a dry cool place.
Correct Disposal of this product
This marking indicates that this product should not be disposed with other household
wastes throughout the EU. To prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly to promote the sustainable
reuse of material resources. To return your used device, please use the return and
collection systems or contact the retailer where the product was purchased. They can
take this product for environmental safe recycling.
- 8 -