Safety Instructions - Norwood LumberPro HD36V2 Manual De Instrucciones

EN
Digital Scale
Operating Instructions
1 2
ABS = Absolute scale value (distance from
the cross-bunk to the blade).
REL = Relative scale value.
1 » Reset the relative scale (REL) to 0.
2 » Switch from absolute scale "ABS" to
the relative scale "REL" . .
3 » Metric / Imperial.
4 + 1 » Set absolute scale to preset value
of 1.0" (25 mm).
5 » Light ON / OFF switch.
Note: The scale cannot be switched off.
41297-INST (2021-04-30).indd 1 41297-INST (2021-04-30).indd 1
3 4 5

Safety Instructions

The sawmill, its options, accessories,
engine and blades (the "equipment")
are extremely dangerous and can
cause severe injury or death. To avoid
serious injury, the equipment must always be
handled, operated and stored with the utmost
care and good judgment and in accordance
with all warnings, cautions, instructions and
procedures contained in this manual, in the
engine manual, in the instructions enclosed
with optional accessories and on the decals
posted on the equipment. Failure to use good
judgment or to follow any of these warnings,
cautions, instructions and procedures can
result in severe injury or death.
WARNING! This symbol means "Pay Extra
Attention" and is always followed by a warning
about a danger that can cause severe injury.
This symbol means "Pay Attention" and is
always followed by a caution or warning of
great importance for safety or sawing results.
For your own safety and the safety of others,
do not begin working with this equipment
before having read and understood this entire
manual, the engine manual, the instructions
enclosed with optional accessories and the decals
posted on the equipment.
Save all instructions for future reference. Keep all decals
in place, clean and readable. Replace any damaged or
missing decals without delay.
Norwood Industries Inc.
2267 15/16 Side Road East
Oro-Medonte ON L0L 1T0
+1-705-325-0030
info@NorwoodSawmills.com
www.NorwoodSawmills.com
EN–1 EN–1
2021-05-01 12:20:20 AM 2021-05-01 12:20:20 AM