Replaceable Parts - Atlantic IAV 080 Manual Del Usuario

5°) MAINTENANCE
Cut the power supply linking the pump control thermostat. Turn the switch on the electric panel feeding the thermostat connected to the power supply.
Push the switch "Summer/Winter" found on the electrical cover of the heat exchanger tank. If you do not have an electric kit, hot water will be produce by the primary
circuit (thermal exchange) - same for winter.
Before removing the cover, switch off the power.
User maintenance: Operates once month the discharge of the water safety device to prevent scaling and verify that it is not blocked. If this is not done, damage
may be caused and the guarantee invalidated. For an installation with a booster pump; before starting up, after a long period of disuse, turn the rotor following the
advice in the manufacturer's instructions.
Maintenance by a qualified person:
a) Remove the scale sludge. Do not scrape or hammer the lime scale deposited on the casing, as this may damage the lining.
b) Appliance with magnesium anode; Change the magnesium anode every 2 years or when its diameter is lower than 10 mm. changing the shielded heating element
or the anode requires the water heater to be drained and the joint changed. DRAIN: Switch off the power and cold water and open the hot water taps before carrying
out these operations. Refit the heating element and tighten the screws smoothly (opposite screws in sequence), check for leaks the next day and tighten if required. If
the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent.
REPLACEABLE PARTS: the thermostat, joint, heating element, pilot light, the magnesium anode, the connection cable, electric switch. The guarantee requires
genuine manufacturer's parts to be used.
ADVICE TO THE USER
When the water has a TH > 20°f, it is recommended that this be treated. When a softener is used, the water hardness must remain above 15°f. When switching
between winter and summer follow the instructions given above, i.e. by stopping circulation of the primary fluid by closing the valve in the system. Winter operation
requires the switching off of the electric power supply (if you have a kit). In case of prolonged absence, especially in winter, drain your appliance following this
procedure.
Do not throw your water heater in the garbage, but drop it in a place assigned for this purpose (collection point) where it can be recycled
6°) GUARANTEE APPLICATION AREA
The water heater must be installed, used and maintained according to the best practices and should comply with the applicable standards in the country in which it is
installed and to the instructions in this document. The sales guarantee covers the free exchange of the tanks and components accepted as defective by our after-sales
service, except wear and tear parts magnesium anode, seal, etc.) And without indemnity or extension of the guarantee. It does not cover labor or carriage charges,
which will be invoiced to you according to our tariffs. It comes into effect on the installation date, authenticated by the sales or installation invoice; in the absence of
proof, the date taken into account will be the date of manufacture shown on the indicator plate of the water heater, increased by 6 months. Costs and damage caused
by faulty installation (frost, no connection to foul water drain, lack of header tank, etc.) or to difficulty of access, cannot under any circumstances be charged to us. Any
claim must be notified to the dealer before exchange under guarantee, and the appliance will remain available to insurance and manufacturer's experts. The provisions
of these terms are not exclusive of the profit benefit of the purchaser, of the legal guarantee for faults and hidden defects which apply in any case under the legal
conditions of each country. Changing a component does not extend the length of the guarantee.
Length of sales guarantee Tank and heater body 3 years Electrical or other component 2 years
To claim under warranty, contact your dealer or ATL International - 58 avenue du Général Leclerc - 92340 BOURG-LA-REINE. Alternatively, contact: the manufacturer
who will inform you what steps to take. The guarantee will only apply to products inspected and agreed to be defective by the company liable for the guarantee. The
products must be kept available for the latter. Exclusions from the guarantee: Wear and tear parts: magnesium anodes....Equipment which cannot be assessed
16