BGS technic 8725 Guia Del Usuario página 4

OPERATION
Piston Height Adaptor (2),
1
to be used as OEM 1 860 992000
Camshaft Adjusting Tools (2),
2
to be used as OEM 1 860 985000
Tension Adjustment Wrench,
3
to be used as OEM 1 860 987000
1. Remove the spark plugs and screw the piston height adaptors into the spark-plug ports of cylinders
one and two.
2. Slowly turn the crankshaft until the notches (1) on the centre rod aligns on each adaptor stem.
3. Important: The dowel pin on the crankshaft must remain opposite the crankshaft position sensor.
4. If necessary re-fit the crankshaft pulley.
5. Remove the two blanking plugs from the camshaft casing.
6. Press the centre pin of the camshaft tool into the alignment slot of the camshaft (2).
7. Secure in place with the threaded hand wheel.
8. It may be necessary to remove the tools and turn the crankshaft one revolution until the tools correctly
engage.
9. After fitting the new timing belt, the tensioner pulley must be turned to the maximum position by using
the wrench (3).
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed