Operation - Lacor HOME Instrucciones De Uso

1.- Take off the wrapping before using the electrical appliance. Do not throw away the wrapping
until you have checked that the appliance functions properly.
2.- Make sure you place the machine onto a flat, hard surface. Avoid contact with excessively
warm areas. Check that the connecting wire and the power point are in perfect condition.
3.- This machine was designed to vacuum-pack solid, dry products. DO NOT USE IT WITH
LIQUIDS OR SAUCES. They may permanently damage the suction pump. If you wish to
pack sauces, freeze them first and, when they are completely hardened, vacuum-pack them.
4.- The bag is sealed using heat, so the necessary safety measures must be followed to avoid
personal injuries.
5.- The bags/reels supplied have been specially manufactured for use with food products. The
heat supplied during the sealing operation was established according to the thickness and
quality of the bags/reels supplied, so the appliance may not work with bags/reels supplied by
other manufacturers.
6.- Do not leave the machine functioning when empty. Prolonged uses can have a negative effect
on the suction pump's lifespan. If the motor overheats, switch it off immediately and wait for it
to cool before using it again.
7.- The "STOP" button cancels and stops the machine immediately at any stage.
8.- Before starting to use the machine, have all the required materials like food products,
vegetables, etc. at hand, as well as scissors, if necessary.
9.- If a plastic reel is used for packing, proceed as follows;
a- Select the desired length and cut with the scissors as straight as possible.
b- Place one of the open sides inside the machine to proceed to seal.
c- Close the lid and make sure it is properly locked.
d- Press the "Seal Only" button and a light will come one during the sealing process.
e- When the light turns off, press the side opening buttons to be able to open the lid.
f- Now proceed as though it were a bag.
10.- If plastic bags are used for packing, proceed as follows:
a- Put the product inside the bag and make sure it is in dry conditions.
b- Place the open side of the bag inside the machine between the suction nozzle and the
lower vacuum pad.
c- Close the lid and make sure it is properly locked.
d- Press the "Vacuum & Seal" button and a light will come on during the vacuum process.
e- Once the product has been vacuumed, the sealing will start automatically, so this
function's light will come on.
f- When the sealing light turns off, press the side opening buttons to be able to open the lid.
11.- Use of adapter and vacuum canisters:
a- Put the product into the canister and fit the lid correctly.
b- Connect the supply wire to the electricity supply.
c- Put the end of the adapter into the suction nozzle located inside the machine.
To vacuu using the adapter, the lid does not have to be closed.
d- Place the other end on the centre of the canister lid.
e- Press the "Vacuum & Seal" button and press the adapter placed on the lid.
f- When the vacuum process has ended, this function's light will turn off.
g- Take out the end of the adapter placed in the suction nozzle.
h- To open a vacuumed canister, turn the control on the lid clockwise.

OPERATION

33