Recharging The Battery; Key Definitions - Uline H-1121 Manual Del Usuario

BAttERy
the scale is equipped with a rechargeable battery. It
can operate continuously by connecting directly to Ac
power or operate 120 hours on a fully charged battery.
When the battery voltage is low, a battery symbol will
start blinking. the scale will automatically turn off 8
hours after the blinking has started.

REcHARGInG tHE BAttERy

the battery display window is located on the front panel
on the left side, next to the word cHARGE. When the
display is RED, the battery is being charged. It will take
8 hours to fully charge the battery. When the display is
GREEn, the scale has been charged to its full capacity.
tARE
to store the tare weight into memory and set the WEIGHt
display as zero:
1. Place an empty container on the platform.
2. Press tARE. the word tARE will be displayed in the
lower left of the WEIGHt display.
the container's weight is then stored in the scale's
memory.
3. Add pieces to the container. As the pieces are
added, their net weight will be displayed.
Users can set a number for counting check. When the
number of objects on the platform is equal to or larger
than the preset checking number the alarm sound
beeps repeatedly.
SEt
1. Press cK key. cH will blink in the WEIGHt display
and the Hi setting will be shown in the UnIt WEIGHt
display.
2. Key in the desired checking number.
3. Press the • key to switch to Lo setting.
4. Key in the desired number.
5. Press cK again to accept.
PAGE 2 OF 15
FUNCTIONS
Removing the container from the platform will cause the
scale to display the container's weight as a negative
number. Pressing the tARE or ZERO key will readjust the
scale to zero.

KEy DEFInItIOnS

ZERO
TARE
SMPL
CE
CK
M+
MC
MR
UWS
COUNTINg ChECK
cLEAR
1. Press the cK key.
2. Press the • key twice to reset.
If there is a minor weight displayed, without
anything on the platform; hit the zero key to
clear the display.
the tare key zeros out the weight of a container
being used to hold small parts.
Sample key. Used when keying in sample
amount.
clear key. clears out the unit weight displayed.
check key. Used when keying in the amount to
check.
Add to the memory.
memory clear. clears out what has been
stored into the memory.
memory recall. Displays what has been
entered into the memory.
Used when manually keying in the unit weight.
0613 IH-1121