Measuring The Density Of A Buoyant Material Using Water; Measuring The Density Of A Solid Using An Auxiliary Liquid; Measuring The Density Of A Liquid Using Acalibrated Sinker - Uline Ohaus Adventurer H-5276 Manual Del Usuario

MEASURING THE DENSITY OF A BUOYANT
MATERIAL USING WATER
Press the ITEM SETTINGS button to open settings screen.
(See Figure 36)
Figure 36
Density Determination
Density Type
Print Settings
Back
Confirm the following Setups are selected:
• Density Type: Solid
• Auxiliary Liquid: Water
• Porous Material: Off
Press BACK to return to the density determination home
screen.
Follow the same procedure as solid material above,
except in density determination step two, push the
sample down into the liquid until it is fully submerged.
MEASURING THE DENSITY OF A SOLID USING AN
AUXILIARY LIQUID
To enable this feature, enter the density determination
setup menu and select the following:
• Density Type: Solid
• Auxiliary Liquid Type: Other
• Porous Material: Off
Confirm the default values displayed (liquid density, etc)
are correct. (See Figure 37)
Figure 37
Density Determination
Density Type
Back
To adjust the liquid density value, touch the
AUXILIARY LIQUID button and select Other.
PAGE 11 OF 54
OPERATION CONTINUED
Auxilliary Liquid Water Temp. Porous Material
Exit
Auxilliary Liquid Porous Material Print Settings
Exit
A numeric input window appears. (See Figure 38)
Figure 38
Liquid Density
1
4
7
Clear
Key in the density in g/cm
returns to the previous screen. To return to the density
determination home screen, touch BACK.
Begin the density determination process as per above.
MEASURING THE DENSITY OF A LIQUID USING A
CALIBRATED SINKER
(not supplied)
To enable this feature, enter the density setup menu
and select the following; Density Type: Liquid.
(See Figure 39)
NOTE: when the density type is set to Liquid, the
liquid type and porous material selections are
disabled.
Density Determination
1.4541
Dry Weight: 249.94 g Liquid Weight:
Oil Weight: 249.94 g Water Temp.:
Item
Start
Settings
Figure 39
Confirm that the default value displayed (sinker volume) is
correct. To edit the default values, touch SINKER VOLUME.
To adjust the sinker volume value, touch the Sinker
Volume button. (See Figure 40)
Figure 40
Density Determination
Density Type
Back
0.9982 g/cm3
2 3
5 6
Save
8 9
Exit
0
•
, then press SAVE. The display
3
The DENSITY
Max 4200 g d=0.01 g
DETERMINATION –
LIQUID home screen
Main Display Line
g/cm3
78.37 g
Reference Fields
20.0º C
Function Buttons
Menu
Sinker Volume Liquid Temp.
Exit
0521 IH-5276
Print Settings