GRAPHITE 59G019 Instrucciones De Uso página 14

The minigrinder is a hand-operated power tool with the insulation class II. The tool is driven with a single-
phase commutator motor. The minigrinder is designed for precise mechanical working of metal, wood,
glass and plastic objects.
All accessories (working tools) supplied with the minigrinder should be used according to their intended
use, bearing in mind type and conditions of the task ahead.
The range of use covers model-making, precise working the above mentioned materials and any work from
the range of individual, amateur activities (DIY)
The power tool should be only used according to its purpose.
DESCRIPTION OF GRAPHIC PAGES
The below list refers to device components shown in the graphic pages of this instruction manual.
1. Nut of the spindle collet
2. Spindle
3. Casing
4. Spindle lock button
5. Carbon brush cover
6. Switch
7. Display
* There can be differences between the drawing and real product.
DESCRIPTION OF USED GRAPHIC SIGNS
CAUTION
WARNING
ASSEMBLY/SETTINGS
INFORMATION
EQUIPMENT AND ACCESSORIES
1. Flexible shaft
2. Special spanner
3. Additional guard
4. Additional handle (fastened to the tool)
5. Various accessories
6. Plastic box
INSTALLATION AND REMOVAL OF THE AUXILIARY HANDLE
The minigrinder can be used with or without the auxiliary handle (14) depending on our needs. Therefore,
the correct guard (3) should be used with a higher or lower flange.
Disconnect the tool from power supply.
●
Loosen and remove the guard (
●
Place the auxiliary handle (
●
Fasten by tightening the correct guard (
INSTALLATION AND REMOVAL OF THE COLLET NUT
Disconnect the tool from power supply.
●
Press and hold the spindle lock button (
●
Rotate the collet nut (
●
Loosen the collet nut, (
CONSTRUCTION AND APPLICATION
- 1 pce
- 1 pce
- 1 pce
- 1 pce
- 190 pcs
- 1 pce
PREPARATION FOR WORK
3).
14) onto the tool casing.
3).
4) to prevent the spindle from rotating.
1) until the spindle lock pin engages in the driving shaft groove.
1) (use the special spanner, if necessary) (fig. A).
8. Speed adjustment buttons
9. Hanger
10. Flexible shaft guard
11. Flexible shaft handle
12. Cord lock collet of the flexible shaft
13. Collet nut of the flexible shaft
14. Auxiliary handle
14