HumanTechnik lisa Instrucciones De Servicio página 10

Baby cry transmitter operation
The baby cry transmitter contains a
built-in microphone to pick-up the
sound of a crying baby. Plug the
transmitter into a convenient mains
socket near to the baby.
On the underside of the transmitter
are two knobs.
The knob labelled S adjusts the
microphone sensitivity.
The knob labelled T adjusts the
length of time the sound must be on
before the transmitter activates.
Knob T in position 0 (fully anti-
clockwise) = minimum respond time
(approx. 0.2 sec.)
Knob T in position 3 (fully clockwise) =
maximum respond time ( approx. 3 sec.)
Knob S in position 0 (fully anti-clock-
wise) = minimum microphone sensitivity
Knob S in position 3 (fully clockwise) =
maximum microphone sensitivity.
An initial setting with high microphone
sensitivity and average response time
(approx. 2.5 sec.) is recommended.
Knob S = 3 (fully clockwise)
Knob T = 1.5 (half way round)
With this setting the transmitter does
not react to short loud sounds, but
reacts to sounds with a constant
sound level that are uninterrupted for
approx. 2.5 seconds (e.g. baby cry).
However, you will need to experiment
with these settings to find the most
convenient settings.
10 English
Additional 4-metre lead microphone
(accessory):
Simply plug the microphone cable
into the socket on the underside of
the baby cry transmitter. The micro-
phone can now be placed very near
to the baby if the built-in microphone
is too far from the baby to pick up the
sound adequately.
Warning
The additional microphone and lead
could prove a danger to a baby or
small child. Ensure that they are well
out of reach.
Important note
All lisa devices connected to the
mains supply have a low power con-
sumption which may lead to the devi-
ce feeling warm. This is normal and
does not interfere with the normal
function of the devices. These signal-
ling systems have a high operational
safety. Should any faults occur in
spite of proper installation and use,
please contact your dealer.
High and low voltage spikes (e.g.
during a thunderstorm) can occur on
the mains supply. The lisa devices
have an integrated electronic control-
ler which may stop working after
these conditions. If this happens sim-
ply unplug each of the devices and
plug them in again.