Publicidad
English
Push firmly inward on the shield holding arms until you hear them click
into place.
Lower the shield past the normal upper stops, and test operation. If the
shield does not seem to work properly, remove and gently reinstall it
again.
TO REMOVE/REPLACE SHIELD HOLDING ARMS ( XC )
To take the shield holding arms off the shield, remove shield as per
previous instruction. Hold the shield/shield holding arms as illustrated<1>.
Push back the lock lever at the lower bracket of the shield holding arm
as illustrated <2> until it stops releasing the lock system. Then slide the
shield holding arm upward <3>, and remove the shield as illustrated <4>.
Repeat for the other side.
〈1〉
〈2〉
〈3〉
〈4〉
10
Publicidad
Capítulos
