Bebecar STYLO Class EL Manual De Instrucciones página 13

GB
IMPORTANT READ CAREFULLY & KEEP
WARNING YOUR CHILDS SAFETY IS YOUR RESPONSIBILITY
WARNING: This pushchair has been designed to be operated as shown in the instructions supplied. Not to do so
may cause damage and render your guarantee void.
1 - TO UNFOLD: Lift handlebar and the pushchair will assume fully open position.
Ensure primary safety locks (A) and secondary lock (B) will correctly engage.
2 - TO FIT THE FRONT AND REAR WHEELS: Place axle in axle housing and press inwards.
Check by pulling wheel to confirm latching of the axle.
3 - TO REMOVE THE FRONT WHEEL: Press down on lever (A) and at the same time pull the wheel away
from the axle housing.
TO REMOVE THE REAR WHEEL: Press lever (B) rearwards and at the same time pull the wheel away
from the axle housing.
4 - STEERING AND NON-STREERING: The front wheels can be used in either mode.
Operate the lever up or down to select.
NB: When on rough ground we recommend raising the lever to lock the wheels.
5 - PARKING DEVICE OPERATION: To apply parking device, press down on pedal.
To release parking device, pull up the pedal.
6 - ADJUSTABLE HANDLE HEIGHT: Press the two buttons simultaneously and raise or lower the handle bar
as required.
7 - TO FIT CARRYCOT: Place carrycot base on chassis attachment device "easylock". Lock will automatically
engage. Warning: Check that the pram body attachment devices are correctly engaged before use.
TO REMOVE CARRYCOT: Push in button on base of the carrycot and simultaneously lift carrycot away
from chassis frame.
8 - TO FIT SEAT: Seat may be forward or rear facing. Place seat on chassis attachment devise "easylock".
Lock will automatically engage.
before use.
TO REMOVE SEAT: Push in button on both side of seat unit and lift seat away from chassis frame.
9 - TO FIT AUTO SEAT: Place auto seat on chassis attachment devise "easylock". Lock will automatically
engage. Warning: Check that the auto seat attachment devices are correctly engaged before use.
TO REMOVE AUTO SEAT: Push in button on back of seat unit and lift auto seat away from chassis frame.
10 - TO FOLD: Firstly press the red button and then simultaneously, turn the handle collar in the direction of the
"FOLD" and the chair will begin to close.
N.B: When opening or folding a pushchair which has an adjustable handle, ensure that the handle is in one
of the middle positions.
11 - Then release secondary safety lock (B) by pressing down and lift handlebar.
12 - Push handle forward until chair is fully folded.
13 - BASKET: Maximum weight load is 5kg evenly distributed. Do not over load.
To attach the basket, pass the webbing and press-stud through the plastic piece as shown on figure A & B.
To attach the bottom part of the basket press clip on to the tube of chassis as shown on figure C.
The carrycot can be transported in the rear seat of the car, when using the Kit SN 5259 according to the
requirements of ECE-R44-04.
FOR FUTURE REFERENCE
Warning: Check that the seat unit attachment devices are correctly engaged