Cooling Mode; Dehumidification Mode - Suntec Wellness KLIMATRONIC COMFORT 7.0 Eco R290 Manual De Instrucciones

Remote Control
High = Set High Fan Speed
Low = Set Low Fan Speed
Up = Up (Temperature +/ Timer +)
Down = Down (Temperature -/ Timer -)
Cool =

Cooling Mode

Dry =

Dehumidification Mode

Fan = Fan Mode
Heat = Heating Mode (Optional)
Sleep = Sleep Mode
°C / °F = Switch Temperature Display between °C und °F
Timer = Timer Mode
Power = Switch Device On / Off
Functions
1. Switch On and Off
- Please press the POWER button to turn on the unit.
The unit starts in fan mode by default. ("Fan" indicator for fan speed lights up)
- Please press the MODE button to select the desired function.
- Please press the POWER button again to turn off the unit.
2. Functions
- The device has three functions: Cooling, ventilation and dehumidification. For night operation, we
recommend that you operate the unit in sleep mode.
Attention: This mode can only be selected via the remote control.
2.1 Cooling Mode
- Please select the cooling mode to lower the temperature in your room
- Please press the MODE button repeatedly until the "Cool" indicator lights up.
- Press the up/down button to set the temperature. The temperature can be set between 16℃ and
32℃.
- Please press the fan speed button repeatedly until the desired indicator lights up.
To control the direction of airflow horizontally, manually adjust the blades on the air outlet.
The air conditioner stops when the room temperature is below the set temperature.
2.2 Fan Mode
- Drücken Sie bitte die MODE-Taste wiederholt, bis der „Fan" -Indikator aufleuchtet.
Im Ventilationsmodus wird die Raumluft umgewälzt, aber nicht gekühlt.
- Bitte drücken Sie die SPEED-Taste, um die hohe oder niedrige Geschwindigkeit auszuwählen.
2.3 Dehumidification Mode
- Press the MODE button on the control panel or remote control until the "Dry" indicator lights up. The
fan speed cannot be selected. The user should connect the drainage hose to the drain at the bottom
of the unit.
Note: In this mode, the fan speed switches to Low and cannot be set.
2.4 Sleep Mode（can only be set via remote control）
The cooling mode can be activated in sleep mode.
-In Cooling Mode:
After 1 hour the preset temperature is automatically increased by 1 ℃, after another hour the preset
temperature is automatically increased again by 1 ℃.