Troubleshooting; Specifications - Sony CDP-CE105 Manual De Instrucciones

Playing CDs Additional Information

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
/Check that the player is connected securely.
/Make sure you operate the amplifier correctly.
The CD does not play.
/There's no CD inside the player ("no dISC"
appears). Insert a CD.
/Place the CD with the label side up on the disc
tray correctly.
/Clean the CD (page 11).
/Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (page 2).
The player functions incorrectly.
/The microcomputer chips may be operating
incorrectly. Turn the power off, then turn it
back on to reset the player.
EN
12

Specifications

Compact disc player
Laser
Semiconductor laser (λ = 780 nm)
Emission duration: continuous
Max 44.6 µW*
Laser output
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response 2 Hz to 20 kHz ± 1.0 dB
Signal-to-noise ratio
More than 100dB
Dynamic range More than 96dB
Harmonic distortion Less than
Channel separation More than 86dB
Output
Maximum
Jack
output
type
level
LINE OUT
Phono 2 V
jacks
(at 50 kilohms)
General
Power requirements
Where purchased Power requirements
Europe and Singapore 220 V
Canada
120 V AC, 60 Hz
Other countries
110 V
adjustable, 50/60 Hz
Power consumption
10 W
430 × 135 × 400 mm
Dimensions (approx.)
(17 × 5 3/8 × 15 3/4 in.) incl. projecting
(w/h/d)
parts
Mass (approx.)
4.5 kg (9 lbs 15 oz)
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs) (1)
Design and specifications are subject to change without notice.
0.01%
Load
impedance
Over 10 kilohms
–
230 V AC, 50/60 Hz
– 120 V or 220 V – 240 V AC,