Comb Attachments - Braun Cruzer 6 Beard & Head Manual Del Usuario

Comb attachments

• The combs can be taken off by pressing the release buttons (1c) with
your thumb and forefinger.
Beard trimming
• Place the beard comb (1a) on the appliance with the appliance turned off
(a).
• Press length selector (6) and slide the beard comb up to your desired
beard length (possible length settings: 1, 3, 5, 7, 9, 11 mm).
• It is advisable to begin with the highest setting and then reduce the
setting until you reach the desired beard length.
• Press the on/off switch (7). Hold the beard comb with the angled edge
against your beard and guide the trimmer against the direction of the hair
growth (a).
• To avoid clogging the beard comb with hair, clean it from time to time with
the brush.
Contour Trimming / Styling
• The wide trimmer (2) evenly cuts and trims large areas. It is ideal for
shaping sideburns, moustaches and partial short beards. Take off the
comb. While stretching the skin, guide the wide trimmer against the
direction of hair growth (b).
• The precision trimmer (3) (model cruZer6 beard&head only) precisely
defines lines and edges and is ideal for precise contouring. To use the
precision trimmer, press the release button (4) and slide it up (c).
Hair cutting
The hair should be clean, well combed, tangle-free and dry.
• Place the hair comb (1b) on the appliance with the appliance turned off (d).
• Press the length selector (6) and slide the hair comb up to your desired
hair length (possible length settings: 10, 12, 14, 16, 18, 20 mm). If you are
not used to clipping hair, begin with a highest setting and then reduce the
setting to avoid cutting more hair than desired. If you want to cut your hair
shorter than 10 mm, we advise to first cut it with the hair comb (1b) down
to 10 mm and then use the beard comb for the desired length.
• Use a slow and controlled movement. Do not force the appliance through
the hair faster than it can be cut.
• In between, shake or blow off the hair. If too much hair is caught in the
comb, remove and clean it.
(1a, 1b)
(model cruZer6 / cruZer5 beard&head only)
13