Technical Features; Accessories On Request - Eurosystems LA ZAPPA Instrucciones De Uso

TILLER : HOW TO START

- Insert the plug into the socket 230 volt,
- Make the wire to pass into the wire-holder (13) then into the rod (10) in order to make it away from the rotating tines (fig. 2).
- Press the yellow switch (1) and pull the lever (2) (fig. 5).
EN
- Once the engine is switched on , let the switch to go (1) making the lever to be still pressed (2) N.B. the electric engine is not showing , at the beginnng
, the same torque of a piston engine , so it is necessary to make the rotavator to be up from the ground making the spur to play ( fig. 1 part 46).
When you get to the tools max rotation speed it is possibile to start working , making the rotavator to touch the ground.
- As far as concerns the unit switching off and the rotavators stopping, slacken the yellow lever (fig. 5 part. 2).
HOW TO DISASSEMBLY ROTAVATORS

To disassemble the rotavators, please unscrew the nut (52), take the screw (56) away and slip the rotavators out. Clean and slightly grease the shaft
before to go on assemblying a new rotavator or another accessories.
HOW TO MAINTAIN – CHANGE OIL

Generally speaking oil should be changed every 60 hours working (viscosity oil sae 80) . Go on as follows : loosen the screw-cap. (fig. 1 part. 59)
and put the unit in on an inclined position and make the oil to flow out . Put in the unit some fresh oil for a quantity about 0,25 lt. In order to verify oil
level put the machine in a horizontal position , unscrew the cap (fig. 1 part. 59) and check the oil to be a little bit less than the hole lower level . The
filling/emptying corresponds to the oil level.
ATTENTION! The used oil must not be drained into the sewer system or waterworks. In order to prevent any pollution to the water-table. Most garages
have used oil deposits, or use the authorized deposits according to your local authority regulations.

TECHNICAL FEATURES


Engine : voltage rating 230V, 50 Hz, power 1300 W.
Transmission : from motor pulley to worm screw by belt; worm-screw-helical gear (in oil-bath) for transmission to drive shaft. Cultivator: with hoes,
working width 36cm., complete with safety case Max tiller speed: 120 RPM. Safety device: all cultivators are equipped with a safety device which
disengages the transmission automatically when the corresponding control lever is released.
NOISE AND VIBRATION LEVEL

Measured sound power level with En709, Lwa = 80,8 dB (A), with a uncertainty value K = ±0,6 dB (A).
Handlebar vibration in compliance with EN 709 and ISO 5349. Level max detected = 1,33 m/s

ACCESSORIES ON REQUEST


Rotavators cm. 16: it is easy to use it for an easier hoeing on narrow rows - De-thatcher: it is good to eliminate the grass entanglement and musk from
fields and gardens – Aerator: it is a good tool for your own garden care as the blades can make little furrows into the ground and aereate it - Ridging
plough: it is necessary to use it to cut small furrows before sowing.
12
The rotavators and aerator and ridging plough can be assembled on the rotavators-holder shaft with screw M8 and nut , after having disassembled the
Measured sound pressure level with En709, Leq = 69,4 dB (A).
, uncertainty value K = ±0,53 m/s
2
.
2