Protecting The Environment - Black+Decker GSL200 Manual Del Usuario

ENGLISH
Guidelines for trimming (Australia & New Zealand)
Trim hedges and shrubs with seasonal leaves (new leaves
u
every year) in December and March.
Trim evergreens in September and February.
u
Trim conifers and other fast growing shrubs every six
u
weeks from October until March.
Maintenance
Your BLACK+DECKER corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance on corded/
cordless power tools:
Switch off and unplug the appliance/tool.
u
Or switch off and remove the battery from the appliance/
u
tool if the appliance/tool has a separate battery pack.
Or run the battery down completely if it is integral and then
u
switch off.
Unplug the charger before cleaning it. Your charger does
u
not require any maintenance apart from regular cleaning.
Regularly clean the ventilation slots in your appliance/tool/
u
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth.
u
Do not use any abrasive or solvent-based cleaner.
Regularly open the chuck and tap it to remove any dust
u
from the interior (when fitted).
After use, carefully clean the blades. After cleaning, apply
u
a film of light machine oil to prevent the blades from
rusting.
Storage
When the tool will not be used for several months, ideally
leave the battery connected to the charger. Otherwise proceed
as follows:
Fully charge the battery.
u
Store the tool in a secure and dry location. The storage
u
temperature must always remain in the range of +10 °C to
+40 °C.
Before using the tool after prolonged storage, fully charge
u
the battery again.

Protecting the environment

Z
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
12
(Original instructions)
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical data
Voltage V
DC
Blade strokes (no load) min
Blade length (shear) cm
Blade gap (shear) mm
Blade length (trimmer) cm
Blade gap (trimmer) mm
Blade brake time
s
Weight
kg
Voltage V
DC
Blade strokes (no load) min
Blade length (shear) cm
Blade gap (shear) mm
Blade length (trimmer) cm
Blade gap (trimmer) mm
Blade brake time s
Weight kg
Charger
Input voltage
Output voltage
Current
Approx. charging time
Weight
Level of sound pressure according to EN 60745:
Sound pressure (L ) 66 dB(A), uncertainty (K) 3 dB(A)
pA
Sound power (L ) 77 dB(A), uncertainty (K) 3 dB(A)
WA
Vibration total values (triax vector sum) according to EN 60745:
(a ) 3.1 m/s , uncertainty (K) 1.5 m/s
2
h
GSL200 (H1) GSL300 (H1)
3.6 3.6
850 850
-1
10 -
23 -
- 15
- 8
< 1 < 1
0.65 0.65
GSL360 (H1) GSL700 (H1)
3.6 7.0
850 850
-1
10 10
23 23
15 15
8 8
< 1 < 1
0.65 0.65
905527xx
905450xx
9062xxxx
V 230 230
AC
V 9
DC
mA 100 120
h 19
kg 0.15 0.15
2
10
14