Troubleshooting - Error Messages - Powis Parker FASTBACK 8x Manual Del Usuario

VIII

TROUBLESHOOTING - ERROR MESSAGES

•
Error Message: "INSERT BOOK"
The operator pressed the Bind button without inserting a
book into the binding recess.
The sheets are not fully justified against the right side of the
binding recess.
The book sensor is damaged
•
Error Message: "USE SMALLER SIZE"
The strip is too wide for the amount of sheets placed in the
binding recess.
The strip is not folded.
The strip is not lined up properly.
The machine is configured to bind the new Lx-Strip and
you tried to bind using the original type L-Strip.
•
Error Message: "BOOK TOO THICK"
You are trying to bind too many sheets with the medium strip. Remove some sheets.
•
Error Message: "USE MEDIUM SIZE"
You are trying to bind too many sheets with a narrow strip.
There is no strip in the binding recess.
•
Error Message: "USE NARROW SIZE"
You are trying to bind too few sheets with a medium strip.
There is no strip in the binding recess.
•
Error Message: "REVERSE STRIP"
The strip is inserted into the machine backwards.
•
Error Message: "MACHINE ERROR XX"
Machine needs technical attention.
All manuals and user guides at all-guides.com
Possible Cause
Possible Cause
Possible Cause
Possible Cause
Possible Cause
Possible Cause
Possible Cause
Place a book into the machine and then press the Bind
button.
Tap the edges of the sheets until the book is flush
against the right side of the binding recess prior to
pressing the BIND button.
Contact your local Fastback® dealer for service.
Add more sheets or use a narrower width strip.
Make sure to fully fold the strip into a 90 degree angle.
Make sure the strip and the sheets are justified against
the back of the binding recess.
In settings, select the L-STRIP ON menu option in the
STRIP MODE Settings menu. See page 18 for details.
Remove some sheets or use a medium width strip.
Insert a medium strip.
Add some sheets or use a narrow width strip.
Insert a narrow strip.
Make sure the short end of the strip is vertical and the
long end of the strip is flat.
Turn the machine off and then back on. If the error still
appears contact your local dealer for technical attention.
FASTBACK MODEL 8x USER'S MANUAL, L4079 Rev. C 04/08/05
Solution
Solution
Solution
Solution
Solution
Solution
Solution
19