Uline VACMASTER H-9461 Manual Del Usuario página 9

INSTALLING CARTRIDGE FILTER
1. Verify that the power cord is
disconnected from the outlet.
(See Figure 40)
2. Remove power head and place
in upside down position.
3. Install the cartridge filter over the
filter cage with the flat end of
the filter toward the power head.
Carefully push filter in until it stops
against the power head.
(See Figures 41-42)
4. Place filter retainer on top of
cartridge filter over the raised
lip and tighten down by turning
retainer clockwise. Do not
overtighten. (See Figures 43-44)
PAGE 9 OF 30
INSTALLING AND CLEANING CARTRIDGE FILTER
Figure 40
Figure 41
Figure 42
Figure 43
Figure 44
REMOVING/CLEANING CARTRIDGE FILTER
1. Unlock and remove the filter retainer by turning
retainer handle counterclockwise.
2. Carefully hold and pull the
cartridge filter up for removal.
(See Figure 45)
3. Clean the cartridge filter by gently tapping or
brushing off dirt. Cleaning should not be done
indoors in living areas. For optimal performance, a
new filter is recommended.
4. Install cleaned or new filter as instructed above in
steps 2 and 3 of Installing Cartridge Filter.
5. Wet filters should be removed and allowed to air dry
for 24 hours before installing onto the filter cage.
IMPORTANT! Clean or change the cartridge
filter regularly for best performance.
WARNING! Always use cartridge filter for dry
vacuuming. If the machine is used without the
cartridge filter, the motor will burn out and the
warranty will be voided. Always keep spare
filters on hand.
WARNING! Always disconnect the plug from the
outlet before removing the power head from
the collection tank.
Figure 45
0821 IH-9461