Emptying The Collection Tank; Cord Storage - Uline VACMASTER H-9461 Manual Del Usuario

EMPTYING THE COLLECTION TANK

WARNING! Ensure power cord is disconnected
before changing the filters.
1. Verify that the power cord is
disconnected from the outlet.
(See Figure 33)
2. Disconnect the hose from
the vacuum by turning in a
counterclockwise direction.
(See Figure 34)
3. Undo the latches and remove the
power head from the collection
tank. (See Figure 35)
4. Clear all dirt or debris from
collection tank and hose.
(See Figure 36)
5. Clean or replace filter.
6. Check the hose, attachments
and power cord to verify that they
have not been damaged.
7. Place power head back onto collection tank and
secure latches.
IMPORTANT! Clean or change the cartridge
filter regularly for best performance.
WARNING! Always use cartridge filter for dry
vacuuming. If the machine is used without the
cartridge filter, the motor will burn out and the
warranty will be voided. Always keep spare
filters on hand.
PAGE 8 OF 30
MAINTENANCE
Figure 33
Figure 34

CORD STORAGE

1.
2. To use the cord storage, rotate
Figure 35
Figure 36
3. When ready to use vacuum,
STORAGE
Before storing, empty and clean collection tank.
Hose should be wrapped with storage racks. Store
accessories so they can be readily available when
needed. Store vacuum indoors.
NOTE: Filters included are made of high-quality
materials designed to stop small dust particles.
The cartridge filter should be used for dry
pickup only. A dry cartridge filter is necessary
to pick up dust. If the cartridge filter is wet,
it will clog quickly and be difficult to clean.
Handle the filter carefully when removing it for
cleaning and replacement. Check the filter for
tears or small holes. A small hole can let dust
pass through and out of the filter. Do not use a
filter with holes or tears; replace it immediately.
WARNING! Always disconnect plug from outlet
before removing power head from collection
tank.
When unpacking the wet/dry vacuum, the cord
storage hooks will be turned inward.
both hooks outward until they click
into place. (See Figures 37-38)
simply rotate one hook inward to
quickly release the cord.
(See Figure 39)
Figure 37
2
Figure 38
Figure 39
0821 IH-9461