Blower Operation - Uline VACMASTER H-9461 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely in the
liquid; leave a gap at the tip of the nozzle opening to allow air inflow. The machine is fitted with a float
valve that stops the suction action when the collection tank reaches its maximum capacity. An increase
in motor speed may take place. When this happens, turn off the machine, disconnect from outlet and
drain the liquid into a suitable receptacle or drain. To continue vacuuming, refit the power head to the
collection tank. After wet vacuuming, turn the machine off and remove plug from outlet. Empty the
collection tank, clean and dry the inside and outside before storage.
NOTE: The foam filter must be removed after wet vacuuming and a cartridge filter must be installed before
dry vacuuming again.
WARNING! Always wear safety goggles
complying with ANSI Z87.1 (or in Canada,
CSA Z94.3) before using blower.
WARNING! Keep bystanders clear from blowing
debris.
WARNING! Wear a dust mask if blowing creates
dust that might be inhaled.
1. Verify that the power cord is
disconnected from the outlet.
(See Figure 29)
2. Ensure collection tank is empty
before using as a blower.
3. Remove hose from the vacuum
port. Remove noise diffuser from
blower port.
4. Insert larger end of hose into
blower port on back side of
power head and lock into place.
(See Figure 30)
PAGE 7 OF 30
LIQUID VACUUM OPERATION CONTINUED

BLOWER OPERATION

Figure 29
Figure 30
5. Fit the desired extension wand and/or nozzle to the
vacuum hose.
6. Verify that the switch is in the off position before
plugging the power cord into the outlet.
7.
Before turning on the vacuum,
firmly hold loose end of the hose.
Turn the motor on by flipping the
switch to the on position.
(See Figure 31)
8. The unit will now blow through the
vacuum hose and can be used
to clear obstructions within the
hose. (See Figure 32)
9. Once blowing is complete, flip
the switch to the off position and
unplug the power cord from the
outlet.
Figure 31
Figure 32
0821 IH-9461

Publicidad

Tabla de contenido
loading

Tabla de contenido