Tabla de contenido
Publicidad
which is connected to the running rails - see
Figure
.
You can use any piece of C Track as the feeder
track.
Plug the power cord (1) for the transformer into the
wall outlet for your household current.
6. Operation
6.1 Delta Addresses
The controler can identify a total of 4 addresses.
1 = Steam Locomotives
2 = Diesel Locomotives
3 = Powered Rail Cars
4 = Electric Locomotives
6.2 Locomotive Address
The locomotive addresses are set at the fac-
tory. The addresses are given in the instructions
for each locomotive. These addresses are not
binding; they can be changed by following the
instructions for the locomotive. If you want to
control a locomotive with the controller in this
set, an address must be set for the locomotive,
which can be selected with the controller. These
addresses are:
Setting on the Address Selection
Switch
1
2
3
4
6.3 Selecting a Locomotive
You look for the locomotive that you want to cont-
rol on the address selector switch (6).
Steam locomotive
selected
Locomotive
Address
78
72
60
24
Diesel locomotive
selected
13
Publicidad
Tabla de contenido
