Krups KM 8005 Manual Del Usuario página 6

2- Put the water tank (a) back in place in the machine. Take care to insert it securely.
3- Insert the jug or thermal jug (h) on its plate/base (g). Be sure that the jug or thermal jug (h) sits flat and
level on the heating plate (g) before starting the brewing cycle.
Note : If you use the jug (h) to fill the tank with cold water rinse the jug (h) with warm water before
starting the brewing cycle. This will help raise the temperature of the coffee in the jug (h).
4- Open the drawer (e) and add paper or permanent filter to the brew basket. (Fig 8)
Krups original accessories:
-#4 paper filters 100-pack. Item # 983
-#4 size gold tone filter. Item # 049
5- Add ground coffee to the basket. (Fig 2)
Measure maximum one rounded coffee scoop per 5 oz. (240 ml) cup water.
- This simple step is crucial to the taste of your brewed coffee.
- See your brewing guide on page 6 for more detail.
6- Close completely the drawer (e). (Fig 3)
As it closes you will feel a magnet secure the draw in place. The machine will not brew if the drawer is
not fully closed.
7- For immediate brewing, press the ON/OFF button (m) and the brew cycle will begin.
The ON/OFF button (m) will glow red while the machine is brewing and stay lit for 2 hours while the
coffee is kept warm on the heating plate (g). (Fig 4)
To use the Auto-On function, see the section "Programming your coffee machine". Real time clock is
displayed on (l).
By default setting, 0:00 is showed.
DURING THE BREWING CYCLE STEAM RISES FROM THE TOP OF THE MACHINE.
BE CAREFUL TO KEEP HANDS AWAY FROM THIS AREA UNTIL AFTER THE BREWING CYCLE
IS COMPLETED !
Auto-Off Function (depending on model):
The heating plate (g) will maintain the temperature in the jug (h) for 2 hours after which the machine shuts off
automatically. This is for safety and convenience. The auto-off time can be adjusted from 30 minutes up to
3 hours in 30 minutes intervals. See page 3 – Programming the machine.
For best results brew only as much coffee as you will drink within 30-60 minutes.
Pause and Serve Feature:
You can remove the jug (h) during the brewing cycles to pour an early cup. Keep in mind that this will
change the taste you would normally get from a full pot in a complete cycle.
Be sure to replace the jug (h) quickly to avoid overflow during the brewing cycle.
Warning
- Put the jug or thermal jug (h) on its plate/base (g) within a maximum of 20 seconds. Hot water
continues to drip in the filter holder (c) when the carafe (h) is removed. The overflow of coffee and hot
water could cause burns.
- Do not exceed the maximum capacity of the water tank (a) as shown by the Maxi level written on the
water tank.
- Place the ground coffee into the paper filter or directly into a permanent filter. After use, discard the
grounds, and rinse the cone filter holder (c) under running water.
- When the machine is hot, do not touch the drawer as the surface may be hot. Use the drawer handle.
PROGRAMMING YOUR COFFEE MAKER (DEPENDING ON MODEL)
English
3