Technical Data - NUK Baby Menu Manual De Instrucciones

Problem
Steaming or blending
does not work
Bowl leaking
Steam escaping from the
edge of the bowl lid
(steam inlet) during steam
cooking
Jerky or noisy operation
The steam cooking
indicator extinguishes
after activation
Ingredients are not mixed
correctly.
Power supply:
Operating humidity:
Protection class:
Degree of protection:
Power rating:
Heat output:
Possible cause
Bowl is not correctly
positioned.
Bowl lid not correctly
positioned.
Device not connected to the
power supply.
No blade fitted.
Seal incorrectly applied.
Seal is porous or damaged.
Bowl damaged.
Bowl lid not correctly applied. Apply the lid to the bowl so that the latter
Hot steam duct blocked.
Lid deformed.
Steam outlet on base unit is
deformed.
The cover for the hot steam
duct is not fitted.
Blade is not correctly fitted.
Bowl is not correctly seated.
No water was filled into the
water tank.
Blade is blunt.
Blade is not correctly fitted.

5. TECHNICAL DATA

220 V - 240 V ~ / 50Hz
20% - 95% relative humidity
I
IPX0
200 W (motor)
500 W
Ensure that the lid is correctly fitted to the
bowl and the latter correctly fitted to the
base unit.
Connect the plug to the wall socket.
Install a blade as described in section
2.2.1.
Apply the seal to the blade with the sealing
lip at the bottom (section 2.2.1).
Use the spare seal.
You require a new bowl. Contact your
relevant dealer (section 3.3).
is fully sealed.
Clean the hot steam duct (section 3.1).
You require a new lid. Contact your
relevant dealer (section 3.3).
Contact your relevant dealer (section 3.3).
Fit the cover to the underside of the lid.
Install the blade as described in section
2.2.1.
Check that the bowl and lid are correctly
fitted and locked in place.
Allow the device to cool and add the
required level of water.
You require a new blade. Contact your
relevant dealer (section 3.3).
Install the blade as described in section
2.2.1.
31
Solution