Further Safety Directions; Correct Handling Of The Battery Charger - Grizzly AKS 1820 T Lion-Set Traducción Del Manual De Instrucciones Original

ing and maintenance instructions
for the saw chain. Decreasing the
depth gauge height can lead to in-
creased kickback.
• Follow instructions for lubricating,
chain tensioning and changing ac-
cessories. Improperly tensioned or
lubricated chain may either break or
increase the chance for kickback.
• Do not saw with the point of the
blade (cf. fig. b)
height. Do not lean over too far dur-
ing the sawing operation.
• Ensure that there are no objects ly-
ing around on the ground that you
can trip over

Further safety directions

• Keep the equipment, cutting attach-
ments and protective blade cover in
good condition in order to prevent in-
jury.
• Ensure during any location change
that the saw chain is secured with
the chain brake and the chainsaw is
switched off and the finger does not
contact the On/Off switch. Carry the
cordless pruner with the chain and
chain bar pointing to the rear. Attach
the chain guard for transporting the
cordless pruner. If dropped, check the
equipment for significant damage or
defects.
• Never start the cordless pruner before
the chain bar, saw chain and sprocket
chain wheel covering are correctly as-
sembled.
• The cordless pruner is designed for
two-handed operation. Never work
with one hand or above shoulder
height.
• Hold the power tool only on the in-
sulated handle surfaces, as the saw
chain can come into contact with con-
or above shoulder
cealed power lines or the mains cable
to the equipment. Contact between
the saw chain and a live wire can
make metal parts of the equipment
live and cause an electric shock.
• Ensure you have a secure stance dur-
ing sawing. Do not work on a ladder,
in the tree or on unstable locations.
Be very cautious carrying out work on
a slope.
• Keep your working area tidy. Only
start work if your working area is
free from obstruction and you have
planned a safe path of escape when
felling timber.
• Place the claw stop securely with
every cut and do not begin with the
sawing before this.
• Be extremely careful during sawing
small bushes and branches. The thin
branch thicket can snag in the saw
and whip in your direction or make
you unbalanced.
• Do not cut wood that is lying on the
ground.
• Pay attention to a possible spring-
back during the sawing of a branch
which is under stress, if the stress
force of the wood is suddenly re-
leased. Danger of injury exists.
• Check the safety status of the cord-
less pruner, in particular the chain bar,
chain brake and the chain, before use.
• In the event that the cutting attach-
ment becomes jammed or stuck in
the branches, do not attempt to free
the equipment with the use of force.
Switch off the equipment immediately
and restart it only after clearing the
blockage. There is a risk of injury!
Correct handling of the bat-
tery charger
• This appliance can be used by chil-
GB
57