Symbols In The Illustrations; Product-Dependent Symbols; Symbols On The Product; Product Information - Hilti SID 14-­A Manual De Instrucciones

1.2.3

Symbols in the illustrations

The following symbols are used in illustrations:
These numbers refer to the corresponding illustrations found at the beginning of these operating
instructions
The numbering reflects the sequence of operations shown in the illustrations and may deviate
from the steps described in the text
Item reference numbers are used in the overview illustrations and refer to the numbers used in
the product overview section
This symbol is intended to draw special attention to certain points when handling the product.
1.3

Product-dependent symbols

1.3.1

Symbols on the product

The following symbols can be used on the product:
Drilling without hammer action
Hammer drilling
Revolutions per minute
Rated speed under no load
Direct current (DC)
Li-ion battery
Hilti Li-ion battery type series used. Observe the information given in the section headed In-
tended use.
The power tool supports near-field communication (NFC) technology, which is compatible with
iOS and Android platforms.
Never use the battery as a striking tool.
Do not drop the battery. Never use a battery that has suffered an impact or is damaged in any
other way.
1.4

Product information

products are designed for professional users and only trained, authorized personnel are
permitted to operate, service and maintain the products. This personnel must be specifically informed about
the possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Cordless screwdriver
Cordless impact wrench
Generation:
Serial no.:
1.5

Declaration of conformity

We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration of conformity can be found at the end of this documentation.
The technical documentation is filed here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | 86916 Kaufering, Germany
*2012667*
2012667
SID 14-A, SID 22-A
SIW 14-A, SIW 22-A
01
English 15