Charge Status Display; Impact Wrench - Hilti SID 14-­A Manual De Instrucciones

The impact wrench may be used only for applications that do not require a precise/specified torque. Failure
to observe this point presents a risk of over-tightening and damage to the bolt, screw or workpiece.
▶ For this product use only Hilti Li­ion batteries of the B14 (SID/SIW 14­A) or B22 (SID/SIW 22­A) series,
as applicable.
▶ Use only the Hilti battery chargers of the C4/36 series for these batteries.
3.3

Charge status display

The charge status of the Li­ion battery is displayed after pressing one of the release buttons lightly (press
only until slight resistance is felt).
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks.
Battery charge status cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
3.4 Items supplied
Impact wrench, operating instructions.
Spare parts, consumables and accessories approved by Hilti for use with the product can be found at
your local Hilti Store or online at: www.hilti.group | USA: www.hilti.com
4

Impact wrench

Rated voltage
Weight in accordance with EPTA
Procedure-01
Rated speed under no
load
Impact speed
Torque adjustment
Large standard bolts
Large high-strength bolts
Socket/bit drive
Ambient temperature for operation
Storage temperature
Rated voltage
Weight in accordance with EPTA
Procedure-01
Rated speed under no
load
*2012667*
Meaning
Charge status: 75 % to 100 %
Charge status: 50 % to 75 %
Charge status: 25 % to 50 %
Charge status: 10 % to 25 %
Charge status: < 10 %
SID 14­A
14.4 V
1.6 kg
Setting I 0 /min ... 1,000 /min
Setting II 0 /min ... 1,500 /min
Setting III 0 /min ... 2,500 /min
≤ 3,100 bpm
3 settings
M8 to M16
M6 to M12
/ " hex. socket with lock-
1
4
ing ring
−17 ℃ ... 60 ℃
−20 ℃ ... 70 ℃
SID 22­A
21.6 V
2.1 kg
Setting I 0 /min ... 1,000 /min
Setting II 0 /min ... 1,500 /min
Setting III 0 /min ... 2,500 /min
2012667
SIW 14­A
14.4 V
1.6 kg
0 /min ... 1,000 /min
0 /min ... 1,500 /min
0 /min ... 2,300 /min
≤ 3,400 bpm
3 settings
M8 to M16
M6 to M12
/ " square drive with
1
2
ball-notch retention
or / " square drive with
3
8
locking ring
−17 ℃ ... 60 ℃
−20 ℃ ... 70 ℃
SIW 22­A
21.6 V
2.1 kg
0 /min ... 1,000 /min
0 /min ... 1,500 /min
0 /min ... 2,300 /min
English 19