Mounting - Tripp-Lite SmartPro SM2200RMDVTAA El Manual Del Propietario

Mounting (Rack)
Mount your equipment in either a 2-post or 4-post rack or rack enclosure. The user must determine the
fitness of hardware and procedures before mounting. If hardware and procedures are not suitable for your
application, contact the manufacturer of your rack or rack enclosure. The procedures described in this
manual are for common rack and rack enclosure types and may not be appropriate for all applications.
Note: The illustrations may differ from your model.
2-Post Mounting
Tripp Lite's 2-Post Rackmount Installation Kit (Model: 2POSTRMKITHD) is included with your UPS
system for rackmounting purposes and convenience.
3U
X 8
1
Important: Illustrations show the most typical installation configuration; your model may vary. Use
only the pre-drilled screw holes to attach mounting brackets to the sides of the unit. When installing
battery packs into the rack, ensure that the weight of the unit is evenly distributed.
4-Post Mounting
Tripp Lite's 4-Post Rackmount Installation Kit (Model: 4POSTRAILKIT) is also included with your UPS
system for rackmounting purposes and convenience.
1
The included plastic pegs
support the empty rackmount shelves
you install the permanent mounting hardware.
Insert a peg near the center of the front and rear
bracket of each shelf as shown. (Each front
bracket has 6 holes and each rear bracket has 3
holes.) The pegs will snap into place.
After installing the pegs, expand each shelf to
match the depth of your rack rails. The pegs
will fit through the square holes in the rack
rails to support the shelves. Refer to the rack
unit labels to confirm that the shelves are level
in all directions. Note: The support ledge of
each shelf must face inward.
2
Secure the shelves
permanently using the included screws and cup
washers as shown.
C
• For 3U equipment mounting, place 6 screws
total at the front and 4 screws total at the
back.
Warning: Do not attempt to install your
equipment until you have inserted and
tightened the required screws. The plastic
pegs will not support the weight of your
equipment.
200912137 93-2968.indb 3
3U
2 X 4
will temporarily
A
while
B
to the mounting rails
B
3
A
1
C
2
3
X 4
B
A
B
C
2/19/2010 10:38:12 AM