Tripp-Lite SmartPro SM2200RMDVTAA El Manual Del Propietario página 4

Mounting (Rack)
3
Attach your equipment's mounting brackets to
the forward mounting holes of the cabinet using
the hardware included with your equipment.
The mounting bracket "ears" should face
forward. (Some equipment may have pre-
installed or integral mounting brackets.)
4
With the aid of an assistant (if necessary), lift
your equipment and slide it into the shelves.
Attach the equipment mounting brackets to the
forward mounting rails with user-supplied
screws and washers
user-supplied nuts are also required.) Tighten
all screws securely.
Mounting (Tower)
Mount all modules in an upright, tower position using included base stands (Model: 2-9USTAND). The
user must determine the fitness of hardware and procedures before mounting.
The UPS system is shipped with two sets of plastic feet
extensions that can be used to tower mount the UPS's power
B
module (3U), a battery module and a second battery module
(up to 9U total).
Adjust the feet to a width of 5.25 inches (13.3 cm) for the UPS
power module. Align the feet in your installation area,
approximately 10 inches (26 cm) apart. Have one or more
assistants help you place the units on their sides in the feet. The
control panel of the UPS should be the UPS's upper corner and
face outward.
200912137 93-2968.indb 4
continued
. (For 3U installation,
D
3
D
4
and
A
Note: Graphic represents a power module,
first and second battery module (9U)
configuration.
4
B
A
2/19/2010 10:38:14 AM