Quick Installation - Tripp-Lite SmartPro SM2200RMDVTAA El Manual Del Propietario

Quick Installation

Insert one of the supplied input cords*
1
or a user-supplied input cord with
country-specific plug into the UPS
system's IEC-320-C20 AC inlet.
*Included input cordsets include:
CEE7/EUI-16P, British BS 1363A and Italian CEI 23-16 to
IEC-320-C19.
2 Plug the UPS into an outlet on a
dedicated circuit.
NOTE! After you plug the UPS into a live AC outlet,
the UPS (in "Standby" mode) will automatically
charge its batteries, but will not supply power to its
outlets until it is turned ON.
3 Plug your equipment into the UPS.*
* Your UPS is designed to support only electronic equipment. You will
overload the UPS if the total VA ratings for all the equipment you
connect exceeds the UPS's Output Capacity. To find your equipment's
VA ratings, look on their nameplates. If the equipment is listed in
amps, multiply the number of amps by 120 to determine VA. (Example:
1 amp × 120 = 120 VA). If you are unsure if you have overloaded the
UPS's outlets, see "OUTPUT LOAD LEVEL" LED description.
Turn the UPS ON.
4
Press and hold the "ON/OFF/STANDBY" button
second. The alarm will beep once briefly after one second
has passed. Release the button.
Note: UPS system will function properly upon initial startup, however,
maximum runtime for the unit's battery will only be accessible after it
has been charged for 24 hours.
200912137 93-2968.indb 5
NEMA 5-20P, Schuko
for one
A
5
1
3
S P
MART RO
A
U P S
4
2/19/2010 10:38:16 AM
®