Power Supply; Using On Ac House Current - Sony CA-DW50 Instrucciones De Montaje

Power supply

OPR/BATT
STANDBY
The OPR/BATT 6STANDBY indicator lights up while
the power is on or the AC cord is connected to an AC
outlet.

Using on AC house current

Connect the AC cord as illustrated below.
supplied AC cord
CAUTION
Use only the supplied AC cord. Use with other cords
may result in the risk of fire.
Using on batteries
Open the lid of the battery compartment on the rear and
insert eight R20 (size D) batteries, not supplied, as
illustrated below. Then close the lid.
To switch from AC power supply to battery supply,
disconnect the AC cord from the AC inlet.
When the OPR/BATT 6STANDBY indicator becomes
dim, the tape speed slows down, volume decreases, or
sound is distorted during operation, replace the
batteries.
Notes on batteries
To avoid damage from leakage or explosion, observe
the following:
• Insert the batteries with the 0 and 9 marks correctly
aligned.
• Do not mix different types of batteries or old batteries
with new ones.
• When the unit is not to be used for a long period,
remove the batteries.
4
ENGLISH
to the AC inlet of the unit
to an AC outlet
(AC 220-240 V,
50/60 Hz)
R20 (D)
• Never recharge the batteries, apply heat to them or
take them apart.
• Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to
remove.
Connections
IMPORTANT
• Make sure that the AC cord is disconnected and
batteries are removed before connecting speakers.
• Do not connect other than the supplied speakers.
1
Position the speakers.
To couple with the speakers, slide each speaker
down into the guide brackets on the center unit until
the height is level with the unit.
To separate the unit from the speakers, slide the
speakers up and off, while pressing the speaker
release knob.
2
Connect the speakers.
Connect the right speaker cord to the R terminals,
and the left speaker to the L terminals.
Connect the speaker cord with the white broken line
to 0 and the other cord to 9.
Release knob