Seav LRX 2137 NEW Manual De Instrucciones página 14

Enabling the programming of a transmission code remotely :
The control unit is supplied by the manufacturer with remote programming of a transmis-
sion code not enabled; to enable the function proceed as follows: connect the control unit
to a 230Vac power supply by pressing and holding the SEL button. All the indicator LEDs
will turn on and the programming is complete. To disable the function enabled previously,
repeat the operation or conduct the RESET procedure.
Programming the transmission code remotely :
This procedure allows to program the transmission code remotely, without using the SEL
button on the unit itself, but remotely following the operation.
To program a transmission code remotely, proceed as follows: send the code of a previ-
ously saved radiocontrol code continuously for more than 10 seconds, at the same time
the control unit enters the programming mode as described above.
Rule of the memorisation of the first Radio control:
In the programming of radio controls, the following rule applies: if the first radio con-
trol to be memorised is a rolling code type, the control unit will then only accept rolling
code radio controls, thus ensuring greater safety against intrusions; if the first radio to be
memorised is a fixed code remote control (12 or 18 bits), then the control unit will accept
both the fixed code and rolling code radio controls having only the fixed part of rolling
codes controlled ((essentially losing the safety feature of the rolling system).
WARNING:
to restore the control unit to factory default configurations (without applying the rule of
the first radio control memorisation), it is required to perform a RESET of the control unit
because it will not enough to erase memorised radio controls.
2) T. MOT: (Programming the motor operating time max. 4 minutes)
The control unit is supplied by the manufacturer with a working time motor predefined
equal to 40 sec.
If the motor operating time has to be reprogrammed, it must be carried out when the
gate is closed, as follows: use the SEL key to move to the flashing T.MOT LED, then
continuously press the SET key. The frame will start moving up. When you have reached
the required height, release the SET key and at the same time the motor time storage
will be completed and the T. MOT. LED will remain lit and steady. If you want an infinite
motor time, use the SEL key to navigate to the T.MOT LED when flashing and press the
SET key for less than 1 second. At the same time the LED will turn off and the operation
will be completed. It is advisable to store a time that is a few seconds longer after the
frame has reached the end.
During programming the radio control key of the control unit can be used instead of the
SET key, if stored previously.
RESET:
To reset the default configuration of the control unit, press the SEL and SET keys simulta-
neously; all RED indicator LEDs will switch on and after a few seconds off again.
MANAGING PROGRAMMING LEDS:
After 3 minutes of inactivity in the programming procedure, the control unit will automati-
cally switch off the programming LEDs to save energy. The LEDs will light up, depending on
the previously set programs, only when the SEL or SET keys are pressed or when a motion
command has been received.
14
Rev. 3.2 31/10/2017