Seav LRX 2137 NEW Manual De Instrucciones página 9

ELECTRONIC PANEL
GB
LRX 2137 NEW
Single-phase electronic control unit for the automation of roller blinds and
sun shades with incorporated radio receiver for the implementation of com-
mands given via Radio control and Command-button.
- Mod. LG 2137 New : Without radio receiver
- Mod. LRS 2137 New : 433,92 Mhz
- Mod. LRS 2137 SET New : 433,92 Mhz narrow band
- Mod. LRH 2137 New : 868,30 Mhz narrow band
I
mportant for the user
- The device can be used by children over
8 years of age and persons with reduced
physical or psychological abilities or with
little knowledge and experience only if
supervised or educated in its operation
and safe use, in order to also understand
the dangers involved in its use.
- these instructions are also available at the
website www.seav.com
- Do not allow children to play with the
device and keep the radio controls
away from their reach.
- Frequently examine the system to
detect any signs of damage. Do not use
the device if it is in need of repair work.
- Always remember to disconnect the
power supply before carrying out any
cleaning or maintenance.
- Cleaning and maintenance must not be
carried out by unsupervised children.
: keep this instruction manual
attentIon
safe and observe the important safety
requirements contained herein. Failure to
comply with the requirements may cause
damage and serious accidents.
I
mportant for the Installer
Before automating the frame, check that
1)
it is in good condition, in compliance
with the Machinery Directive and with
EN 12604.
2) Check that the location where the
installation is located enables compli-
9