TEFAL KO853840 Manual De Instrucciones página 13

USE
1. TO OPEN THE LID, ACCORDING TO THE MODEL
– Press on the locking system and the lid lifts automatically.
To close, press down firmly on the lid.
2. PLACE THE BASE ON A FLAT, STABLE, HEAT-RESISTANT SURFACE AWAY FROM WATER
SPLASHES AND ANY SOURCES OF HEAT.
• Kettle is only to be used with the base provided.
3. FILL THE KETTLE WITH THE DESIRED AMOUNT OF WATER.
• Never fill the kettle when it is on its base.
• Do not fill it above the maximum level, or below the minimum level. If the kettle is too full,
boiling water may spill out.
• Do not use without water.
• Check that the lid is closed properly before use.
4. POSITION THE KETTLE ON ITS BASE. PLUG IT INTO THE MAINS SOCKET.
5. TO START THE KETTLE
When the kettle is placed on the base, all the lights illuminate. The water temperature in the kettle
is displayed on-screen.
TO HEAT WATER:
2 options:
– If you wish to start a boil cycle, press the
100°C appears directly on the screen, the kettle beeps and starts heating the water.
The kettle beeps twice once water temperature reaches 100°C.
• If you wish to select the temperature – 5 possible settings: 40°C – 70°C – 80°C – 90°C – 100°C –
press the key until it displays the temperature you wish to select. The selected temperature
blinks twice, then stays still. The kettle beeps and the kettle starts heating the water.
You can monitor the live temperature of the water on the screen.
Once the selected temperature is reached, the kettle beeps twice and stops heating.
KEEP WARM MODE
You can use the keep warm mode to keep the water at a selected temperature during 30 minutes.
Once the temperature has been selected, a long push on
The logo appears at the top of the screen.
You can also start the keep warm mode once the temperature has been reached. Do a long push
on the key. The logo
If you wish to turn off the keep warm mode, just press the
PLEASE NOTE
The long push will activate the keep warm only if you push the button less than 25 seconds after
the end of the boiling cycle, otherwise the screen will switch off.
PLEASE NOTE
The screen automatically switches off after 25 seconds – unless you have selected the keep warm
mode – but pressing any key will turn the screen on again anytime.
If you select 100°C and activate the keep warm function, the kettle keeps the temperature at 95°C
for 30mins.
If the temperature of the water in the kettle is higher than the temperature you select when
pressing , the heating won't start.
For instance, if the water temperature is 90°C, you won't be able to launch the heating by
selecting 40°C, 70°C or 80°C.
will appear at the top of the screen.
11
(fig 2)
(fig 3)
button
will activate the keep warm mode.
key.
EN