GE 840173101 Manual De Instrucciones página 5

840173101 Ev01 1/18/08
Iron
1. The Water Tank of your iron should be emptied after each use. Set Fabric Setting
Indicator to OFF
( O )
until Water Tank Opening is parallel with sink. Water will run out of water tank
opening.
2. After iron has completely cooled, fully retract cord into iron and store in an upright
position. Do not store iron laying flat on soleplate.
Soleplate
1. Never iron over zippers, pins, metal rivets, or snaps, as these may scratch the
soleplate.
2. To clean occasional build-up on the soleplate, wipe with a sudsy cloth. Do not use
abrasive cleansers or metal scouring pads.
3. Always store iron upright in the heel rest position.
Self-Clean
To keep the steam vents clear of any build-up, follow these instructions each time
you iron using steam.
1. Set Fabric Setting Indicator to OFF
capacity.
2. Set Adjustable Steam to Dry Iron position. Set Fabric Setting Indicator to Linen
setting and let iron heat for 2 minutes.
3. Set Fabric Setting Indicator to OFF
soleplate facing down.
4. Press and hold the Self Clean Button. Boiling water and steam will flow out of steam
vents. Allow all water to drain from iron.
5. Gently move iron front to back to allow water to clean entire soleplate area.
6. If water still remains inside of soleplate, reheat iron as indicated in Step 2. Boiling
water and steam could still flow out of steam vents.
Blast of Steam and Spray Buttons
Push Steam Button for an extra blast of steam. Push Spray Button to release a fine
Spray Steam
9:27 AM Page 5
CARING FOR YOUR IRON
. Unplug the iron and hold over a sink. Turn iron upside down
. Fill iron with water to
( O )
. Unplug iron and hold over a sink with
( O )
FEATURES
(on selected models)
spray of water for difficult wrinkles in cotton or linen.
1 ⁄ of its maximum
2
5