Air Conditioner Use; Important - Whirlpool ACM184PT0 Manual De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
Electrical Shock Hazard
Connect green ground wire to ground screw.
Failure to do so can result in death or electrical shock.
3. Connect the green ground wire to the ground screw.
Position the ground wire pointing straight up. Put the excess
ground wire between the coil and the air conditioner cabinet.
A. Green ground wire
B. Ground screw
4. Push front panel straight on and then lower it slightly to lock it
into place.
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.

IMPORTANT:

If you turn off the air conditioner, wait at least 3 minutes
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
5. Using 2 - #10 x ³⁄₈" painted round-head screws, attach the
NOTE: For through-the-wall installations, if needed, install the
molding around the room side of cabinet.
A
B
6. Plug into a grounded 3 prong outlet.
7. Press RESET on the power supply cord. See "Electrical

AIR CONDITIONER USE

NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
bottom front of the panel.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Requirements."
Do not try to operate your air conditioner in the cooling mode
when outside temperature is below 65°F (18°C). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Acm184pt1

Tabla de contenido