Troubleshooting Guide - EINHELL GE-SP 18 Li Manual De Instrucciones

11. Troubleshooting guide

Faults
The equipment Battery is not correctly inserted
does not start
The equipment - Intake sieve clogged
does not pump - Discharge hose kinked
Insuffi cient pumping - Intake sieve clogged
rate - Performance reduced due to heavi-
- Battery performance decreasing
The equipment swit- - Motor circuit-breaker switches the
ches off after briefl y
running
- Water temperature too high; motor
Anl_GE_SP_18_Li_SPK9.indb 23 Anl_GE_SP_18_Li_SPK9.indb 23
GB
Cause
ly contaminated and abrasive water
impurities
equipment off due to excessive wa-
ter contamination
circuit-breaker switches the equip-
ment off
- 23 -
Autogoods "130"
Remedy
Remove battery and insert again
- Clean intake sieve with water jet
- Unkink the hose
- Clean intake sieve
- Clean equipment and replace wear
parts
- Check the battery performance and
charge the battery if necessary
- Unplug power plug and clean
equipment and shaft
- Ensure that maximum permissible
water temperature (35 °C) is not
exceeded
04.08.2020 13:34:38 04.08.2020 13:34:38