Assembly; Fuelling - AL-KO T15-105.6 Hd-A Manual De Instrucciones

After rectification of the malfunction (see trou-
„
bleshooting table) and inspection of the unit
After cleaning the unit
„
„ Do not start the motor if you are standing in front of
the discharge chute
„ Check the terrain to be mowed completely and
carefully and remove all foreign bodies.
„ Be especially careful when turning the lawn mower
around or when pulling the lawn mower towards
you
„ Do not mow over obstacles (e.g. branches, roots
of trees)
„ Only remove cuttings when the motor is at a stand-
still.
„ Switch the motor / cutting blades off when an area
other than the area to be mowed is crossed
„ Never lift or carry the unit while the motor is run-
ning.
„ Do not eat or drink while refuelling or adding motor
oil
„ Do not breathe in fuel vapours
„ Guide the unit at walking speed
„ Before use, make sure the seat of nuts, screws,
and bolts is firm.
„ Close the throttle valve* when running out the mo-
tor. If the motor has a fuel stopcock, it should be
closed after mowing
*depending on version

Assembly

Observe the enclosed installation instructions.
Attention!
The unit must only be operated after it has been
fully assembled

Fuelling

You must fill up the lawn mower before using.
Warning - risk of fire!
Petrol and oil are highly flammable!
Always observe the applied operating instructions
of the motor manufacturer.
Operating material
Petrol
Normal petrol /
Type
lead-free
See information
Filling
of the motor
quantities
manufacturer
Safety
Warning!
Never run the motor in enclosed spaces. Risk of
poisoning!
„ Store petrol and oil in suitable containers
„ Only fill or empty petrol and oil outdoors when the
motor is cold
„ Never fill petrol or oil when the motor is running
„ Do not overfill the fuel tank (petrol expands)
„ Do not smoke while refuelling
„ Do not open the fuel tank while the motor is running
or if the motor is hot
„ Replace damaged fuel tank or fuel tank cap
„ Always close the fuel tank tightly
„ If fuel overflows never attempt to start the motor.
Instead, move the machine away from the fuel
contaminated area. Avoid any attempt to start the
ignition until the fuel vapours have evaporated.
„ If motor oil has leaked out:
Do not start the motor
„
Soak up the leaked motor oil using an oil bind-
„
ing agent or rag and dispose of it properly
GB
Motor oil
See information
of the motor
manufacturer
Approx. 0.6 L
25