Assembly; Startup; Operation - AL-KO COMFORT 38.5 Li Traducción Del Manual De Instrucciones Original

en
Switch the motor off when an area other than
the area to be mowed is crossed
Never lift or carry the mower while the motor
is running
Never leave the mower unattended when it is
ready for operation

ASSEMBLY

Assemble according to enclosed assembly in-
structions.
CAUTION!
The mower must only be operated after
it has been fully assembled!

STARTUP

Charging the battery (1)
The battery is supplied partially charged!
Fully charge the battery before the first
use.
The battery can be charged in any
charge level. Interrupting charging does
not damage the battery.
CAUTION!
When pulling out the battery, press and
hold the engagement button on the un-
derside of the battery so the battery will
be unlocked.
1. Push the battery into the charger and connect
the charger to the mains. Charging starts, and
is indicated by the green light-emitting diode
(LED) flashing.
2. The battery is fully charged when the LED of
the charger lights up green without flashing.
3. Disconnect the plug from the mains.
4. Pull the battery out of the charger.
Green LED lights: battery charged
Green LED flashes: battery charges
LED lights red: no battery inserted in
charger
red LED flashes: battery too hot
18
The temperature range for the charging
process should between 0° C and +40°
C.
The maximum time for a full charge is
2 hours. If the operating period of the
battery is greatly reduced in spite of a
full charge, the battery is worn out and
should be replaced with a new original
battery.
Inserting the battery (2-5)
1. Press on the battery cover on the mower to
open it.(2)
2. Remove the safety key from the mower.(3a)
3. With a slight pressure push the battery into
the battery compartment up to the stop until
the battery sits firmly on the contact plug of
the mower. (4)
4. Insert the safety key again and turn it.(3b)
5. Press once on the battery cover to close it. (5)

OPERATION

Adjusting the cutting height (6)
CAUTION!
Danger - risk of injury!
Adjust the cutting height only while motor
is switched off and the cutting blade has
stopped!
1. To unlock, press the lever to the side and hold
(4).
For a short lawn slide the lever in the di-
rection of the front wheel. Minimum step
1: 3 cm
For a longer lawn slide the lever in the di-
rection of the rear wheel. Maximum step
6: 7 cm
2. Release the lever and slide it forward or back-
ward until it engages in the desired step.
Attaching the grass catcher (7)
CAUTION!
Danger - risk of injury!
Remove or replace the grass catcher
only while the motor is switched off and
the cutting blade has stopped.
1. Lift up the baffle plate and hang the grass cat-
cher into the holders. (7a-b)
Safety instructions
441600_a