•
Slack coal
•
Other wastes
•
Paper and cardboard (except for igniting)
•
Straw
Please note before heating for the first
time
•
Remove all accessories from the ash pan and
combustion chamber first.
•
The odour given off by the evaporation of the
protective coating disappears after the stove has
been burning for several hours (ventilate the
room well).
•
The stove has a high quality temperature re-
sistant coat, which does not achieve its final
strength until the stove has been heated for the
first time.
- You should therefore never leave anything on
the stove and not touch the surfaces as the paint
coat could otherwise be damaged.
Igniting
•
Empty the ash pan if necessary and slide back
in.
•
Open the primary and secondary air controller.
•
Place the kindling material (ignition cubes and
kindling wood) as described and ignite it from the
top.
•
Place and ignite the kindling materials (paper,
ignition cubes, kindling wood, etc.).
•
Close the door to the combustion chamber so
that the kindling material can catch fire.
•
As soon as the kindling material has burned
down, put on 2 burnouts consisting of 3 kgs wood
ensuring that the temperature resistant coating
reaches its final firmness.
Using the combustion air slide valve
Operating lever for combustion air supply
Operating lever on "0" = All slide valves closed
Operating lever on "I" = Secondary air slide valve
Operating lever on "II" = Secondary air slide valve
Regulation of combustion air
Position of operating lever:
"II"
Ignition position, max. heat output
"I"
Rated heat output with billet wood
"I"
Rated heat output with wood briquettes
"0"
Obtain glow
•
As the secondary air also contributes to the
cleanliness of the glass pane, the lever should be
set on "I" minimum.
•
When not operating the lever should be set on
"0", to reduce the cooling down of the room.
completely open/
Primary air slide valve
completely closed
completely open/
Primary air slide valve
completely open
11