Please Note Before Heating For The First Time; Permissible Fuels; Operation; Igniting - Olsberg Turia Lina Compact 23/625 Manual De Instrucciones

Operation

Permissible fuels

The following fuels are approved:
● Natural shopped wood in the form of billet wood
Maximum length: ..............33 cm
Circumference: ....approx. 30 cm
● Wood briquettes to DIN EN 14961
Size class HP 2
Maximum length: ..............20 cm
● Lignite briquettes
Billet wood reaches a moisture content of 10 to 15%
after being stored outdoors for 2 to 3 years (only cov-
ered at the top) and is then ideally suited for heating.
Freshly cut wood has a very high moisture content
and so burns badly. Apart from the very low calorif-
ic value it is also harmful for the environment. The in-
place and chimney sooting.
This diagram shows that the consumption rate with
most twice as high as the consumption rate with dry
You will only achieve optimum combustion and heat
Caloric value [kWh/kg]
in an environmentally friendly way with these fuels.
dry wood that has been stored for at least 2 years
Adding the fuel in small quantities avoids unnecessary
According to the German Federal Immission Control
Act, it is forbidden e.g. to burn the following fuels in
stoves:
● Moist wood or wood treated with wood preserv-
atives
● Sawdust, chippings, grinding dust
creased condensate and tar formation can lead to fire-
● Bark and chipboard waste
● Slack coal
● Other wastes
freshly-felled wood (calorific value 2.3 kWh/kg) is al-
● Paper and cardboard (except for igniting)
● Straw
wood (calorific value 4.3 kWh/kg).
16
emissions. Clean burning can be identified by the fact
that the firebrick becomes a light colour.
freshly-felled wood
Moisture [%]
● Remove all accessories from the ash pan and com-
bustion chamber.
● The odour given off by the evaporation of the pro-
tective coating disappears after the stove has been
burning for several hours (ventilate the room well).
● The stove has a high quality temperature resistant
should therefore never leave anything on the stove
and not touch the surfaces as the paint coat could
otherwise be damaged.
● As soon as the kindling material has burned down,

Igniting

put on 2 burnouts consisting of 3 kg wood ensuring
placed on the stove.
● Empty the ash pan if necessary and slide back in.
● Open the combustion air slide valve complete.
● Grate in open position = operating lever pulled out
● Place the ignition material (ignition cubes and dry,
smaller ignition wood) and ignite it.
● Close the combustion chamber door so that the kin-
● As soon as the igniting material is burning, add a

Please note before heating for the first time

quantity of fuel corresponding with the required heat
(see chapter "heating").
Caution:
in the chimney, and ventilation devices/systems are op-
coat, which does not achieve its final strength un-
window in the installation room or temporarily switching
til the stove has been heated for the first time. You
off the ventilation system can help.
that the temperature resistant coating reaches its fi-
nal firmness.
● Before ignition, check that no flammable objects are
dling material can catch fire.
When heating up the fireplace, difficulties in igniting the
firewood can occur if a flue draught has not yet formed
erated at the same time. In this case briefly opening a